| What are the basic procedure of sea rods |
| Author:none 14-8-6 11:1 Read:1199 |
Sea rods although length is different, but the use of roughly the same, the basic procedure is as follows: ( 1 ) by section opened the sea rod, so that the coil alignment, and in a straight line, the connections should be slightly Afterburner Tension. A coil with quasi reel seat. ( 2 ) Ann reel, the reel on deck, nut fixed to the death, the reel stop switch Shifting to reverse position, pull the thread, fishing line is pulled out, and then one by one through the coil, through the rod tip across the coil until the. And then the connecting rings hanging aconite and bomb bait, ready to dump. ( 3 ) to check switch back to the forward position, adjust good drag device, which is very important. Too tight, wire resistance Too big, big fish is easy to break; too loose, outlet resistance is too small, in the big fish out quickly, later than the line as line. The general is a hand pull fishing line, to pull the fishing line can be. ( 4 ) spinning reel, the bait from the rod tip 30~40 Cm. Then the right hand grip on the reel, with the middle finger And ring finger clip on wire wheel is connected with the back, the index finger first joint hook fishing line, turning round ring, as you are familiar with the dump The hook bait to catch. ( 5 ) The Radix Aconiti water, Immediately back outlet ring shake the reel handle line, When the wire back part, The line is still in a state of relaxation, the sea rod is placed on the bracket, the sea rod elevation (rod body and ground into the) should be Large, should be steep, there is a direct relationship between the size and the elevation rod tip response sensitivity. In general, the elevation angle is greater, The higher the sensitivity; conversely, the more slowly. Discriminant elevation is suitable not standard is the angle between the fishing rod and fishing line, When the angle is more close to 90 ° The reaction is more sensitive. Therefore, the angle is the core response sensitivity. Sea rods Well, then in the rod tip with a bell. ( 6 In case of windy weather, high elevation) will make the rod easily affected by the wind swinging. In order to enhance the wind sea rod Ability, can be the angle decreased, but not too small, that will make the rod tip sensitivity is reduced; in addition, also can be the sea Rod back sections, that the rod is reduced, can also reduce the influence of wind; or the sea rod lateral to the shore, but should pay attention to The fishing rod and fishing angle between lines, so close 90 ° ( 7 Sea rods) good, can watch the reaction, or listen to the bell ringing, or see the rod tip. When you see the rod tip a sharp swing Or ringing, but into the holding pole back to Yang pole, then rapid take-up, received a few noodle, and Yang pole again, so repeated several times, to make the hook fastened lips. ( 8 After the bait into the water, after) 20~30 Minutes still no reaction, then it should rod, re bait. Because Bait into the water after will soon spread, after half an hour, will be small fish eat bait, bait will not change in vain when Between. |
| From: |
